Differences

This shows you the differences between the selected revision and the current version of the page.

--- fzr600 2010/06/21 00:48
+++ fzr600 2010/06/21 00:58 current
@@ Line 59: / Line 59: @@
 {{:yzf600wiringdiagram.jpg?360|Click To Enlarge}}
-----
-^^^^      ^^^^
+==== Gear ratios ====
+=== FZR 600 ===
-^  FZR 600 Gear Ratios  ^^
 |  1  |  2.846  |
 |  2  |  1.947  |
 |  3  |  1.55   |
 |  4  |  1.333  |
 |  5  |  1.192  |
 |  6  |  1.111  |
-^Primary reduction ratio 1.708  ^^
-^Secondary reduction ratio 3  ^^
+Primary reduction ratio: 1.708
-\\
-^     ** FZR 600 Wheel Bearings**  ^^^^
+Secondary reduction ratio: 3.0
+==== Wheel bearings ====
+=== FZR 600 ===
 ^Front wheel|6302-2RS|2 Pieces | 15mm i/d, 42mm o/d, 13mm thick |
 ^Rear wheel|6303-2RS|1 piece|17mm i/d, 47mm o/d , 14mm thick |
@@ Line 82: / Line 87: @@
 ^Top Steering Stem Bearing|Koyo 32005JR|1 Piece|
 ^Peanut Cover Bearing |NTN 6200|1 Piece|
-\\
-^  To try the FAT axle modification and get the front suspension to work PROPERLY  ^^^^
-^Front wheel|6004-2RS|Which will take **20 mm axle** same outer diam BUT 1mm thinner than stock|
-^Front Wheel|61905-2RS|Which will take a ** 25mm axle** same outer diam BUT is 4MM thinner than stock|
-^  PLEASE note you will have to bore your forks, speedo, spacers, and the centre spacer for this mod.  ^^^^
-<sup>There are also Imperial sizes that could work but you can research those for yourselves</sup>\\
-<sup>:!:IF you decide on 25mm axles consult a bearing specialist house FIRST as the front wheel load is now running on a 25% reduced surface and therefore may be over stressed.:!:</sup>
-\\
 ^  **Stock Bandit 600 rear wheel bearings**  ^^^^
 ^Bearing | 6204-2RS| 2pieces | 20mm i/d, 47mm o/d, 14mm thick |
@@ Line 95: / Line 93: @@
 ^ **To use bandit 600 wheel on 3HE axle** ^^^^
 ^Bearing| 6303-2RS |2 pieces| 17mm i/d, 47mm o/d, 14mm thick|
-\\
+^  To try the FAT axle modification and get the front suspension to work PROPERLY  ^^^^
+^Front wheel|6004-2RS|Which will take **20 mm axle** same outer diam BUT 1mm thinner than stock|
+^Front Wheel|61905-2RS|Which will take a ** 25mm axle** same outer diam BUT is 4MM thinner than stock|
+^  PLEASE note you will have to bore your forks, speedo, spacers, and the centre spacer for this mod.  ^^^^
+:!:IF you decide on 25mm axles, consult a bearing specialist house FIRST, as the front wheel load is now running on a 25% reduced surface and therefore may be over stressed.:!:
-===== Gallery =====