Page 1 of 1

Tachometer Resistor Questions

Posted: Tue Apr 10, 2012 10:06 am
by Nunya_Binnez
I need to replace the big blue 51ohm resistor in my tachometer as it was fried when the VRR failed on the PO of my bike.

The info I have gleaned from the forum on the required specs are:

51ohm, 5w, 5%

The questions I have are;

1) is this info correct?
2) wire wound or metal oxide?
3) any other important info I should know?

Thanks in advance. :notworthy:

NDB

Re: Tachometer Resistor Questions

Posted: Tue Apr 10, 2012 10:19 am
by Camala_Pillion
Nunya_Binnez wrote:I need to replace the big blue 51ohm resistor in my tachometer as it was fried when the VRR failed on the PO of my bike.

The info I have gleaned from the forum on the required specs are:

51ohm, 5w, 5%

The questions I have are;

1) is this info correct?
2) wire wound or metal oxide?
3) any other important info I should know?

Thanks in advance. :notworthy:

NDB


Hi,
think that was covered by Trifgeorge or DonTZ in the post archives or the WIKI.

Re: Tachometer Resistor Questions

Posted: Tue Apr 10, 2012 10:25 am
by Nunya_Binnez
That's where I found the info that I have already gleaned, but left me with the questions in my OP.

NDB